Memorex LOCK - VERSION 2-24 Spezifikationen PDF herunterladen (Seite 166)

Autoattach Installation for VM/SP, VM/HPO, and VM/ESA 370

3-42 BIM-EPIC Installation and System Guide

These instructions are only a guideline to show the steps necessary to successfully install the

Autoattach feature. This feature is distributed as a modification to IBM’s VM product. If

these instructions are unclear, incomplete or conflicting, you should consult your IBM VM/SP

or VM/HPO INSTALLATION AND SERVICE manuals for definitive procedures. If you

experience problems with the Autoattach feature, please contact BIM-EPIC Technical

Support.

The term Local Service Disk refers to the MAINT minidisk where your own installation

modifications to CP are maintained. For these instructions we will assume that the MAINT

191 A-disk is being used. Many sites use MAINT 295, as well as other disks for the ‘Local

Service’ function. Whichever minidisk you use, it must be accessed ahead of IBM service for

Autoattach to be installed successfully.

Before installing Autoattach, back up your running CP nucleus. Also back up the MAINT

local service disk.

DDR

Invoke the DASD Dump/Restore program.

input cuu 33xx volume

Specify your CP sysres address,

OUTPUT cuu 34xx

DASD type and volid.

DUMP NUCLEUS

DUMP NUCLEUS will provide the nucleus cylinders as

well as the IPL tracks on cylinder 0.

VMFPLC2 DUMP * * A

Back up the local service disk using VMFPLC2 or your

own procedure.

Before performing any installation steps, verify that MAINT service is complete by generating

a new CP nucleus and testing it. Follow step 11 of this script to generate a CP nucleus and

then IPL your machine. If no problems are detected, proceed to STEP 3.

Set up the MAINT environment with 16 megabytes of storage and access to all CP minidisks.

DEFINE STOR 16M

IPL 190

Access the CP minidisks

VMFSETUP 5664167E CP ( ALL

for VM/SP Release 6

SPGEN SETUP CP

for VM/SP Release 5

procedure-name

Use your own procedure for prior VM

releases.

Load the Autoattach files from the distribution tape.

During a BIM-EPIC installation, the Autoattach files are loaded to a VSE library. Execute

LIBR as shown below, using your userid and sublibrary name. The PUNCH (PU) line above

must be specified exactly as shown. Output is sent to the issuing machine.

* $$ JOB JNM=LIBR,CLASS=A,LDEST=(,

userid

),PDEST=(,

userid

)

// JOB LIBR

STEP 1

STEP 2

STEP 3

STEP 4

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 358 359

Kommentare zu diesen Handbüchern

Keine Kommentare

Memorex LOCK - VERSION 2-24 Spezifikationen Seite 166

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Memorex LOCK - VERSION 2-24