Memorex LOCK - VERSION 2-24 Spezifikationen PDF herunterladen (Seite 67)

Defining the BIM-EPIC Environment Creating the TSIDPOL Phase

Chapter 2. Installing the Basic System 2-39

Defining the BIM-EPIC Environment

Creating the TSIDPOL Phase

The TSIDPOL phase is required to enable BIM-EPIC’s disk management services and also if

you want to use the tape pooling facility.

To create the TSIDPOL phase, you must assemble and link the TSIDPOL and TSIDMAP

macros. This is accomplished through six separate tasks in this installation procedure:

• Designing disk pools

• Creating disk pool statements

• Designing tape pools

•

Creating tape pool statements

•

Specifying the TSIDMAP macro

• Assembling the macros and cataloging the TSIDPOL phase

A sample job stream to assemble and catalog the TSIDPOL phase can be found on page 2-50

and also as member TSIDPOL.Z in the BIM-EPIC installation sublibrary.

If you are upgrading from an earlier release of BIM-EPIC, you must reassemble the

TSIDPOL phase.

You can change the options you specify in the TSIDPOL and TSIDMAP macros at any time.

However, since TSIDPOL resides in the SVA, activating a new pool definition while BIM-

EPIC is active requires the following procedure:

Step Action

Turn BIM-EPIC off.

2 Execute a SET SDL in the BG partition to reload the new TSIDPOL phase into the

SVA.

Turn BIM-EPIC back on again.

// JOB ACTIVATE NEW TSIDPOL

// EXEC TSIDOFF

SET SDL

TSIDPOL,SVA

// EXEC PROC=EPICON

Description

WARNING!

Activating a New

TSIDPOL Phase

Example

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 358 359

Keine Kommentare

Memorex LOCK - VERSION 2-24 Spezifikationen Seite 67