Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 30)

28 | Keypad & Display Description

NAV5 - Compass Display Screen

The NAV5 screen displays the Heading and Rate of Turn values of the MX575 Satellite

Compass (or Gyro) in digital and compass row formats. In addition, it also displays the

position, COG, SOG, BRG, and RNG. This screen can be accessed by pressing the NAV

key repeatedly until you reach the desired NAV screen.

NAV6 - Compass Display Screen

The NAV6 screen displays the Heading and Rate of Turn of the MX575 in large digital and

tape measure style readouts. In addition, it also displays the Set and Drift. This screen

can be accessed by pressing the NAV key repeatedly until you reach the desired NAV

screen.

The NAV1 - NAV5 screens are not active until the antenna is detected.

Route

There are two RTE screens. The NAV functions are highly interactive with the RTE1

screen. The RTE2 screen allows you to create a pool of predetermined routes that you

might use often, so you need only create the route one time. Routes are created from

waypoints. All waypoints are stored in the Waypoint Bank, regardless of which function

is used to create them. Waypoints are either created in the Waypoint Bank (WPT1),

created by the GOTO function, selected from the PLOT screens in conjunction with the

GOTO function, or from New Waypoints that can be defined in the Route Insert menu

(and simultaneously stored in the route and the Waypoint Bank).

We recognize the diverse needs of professional users. We have designed the route

features to be very flexible to meet a wide range of users’ requirements by allowing

up to 2000 waypoints to be stored between all of the routes. You can create up to

99 routes, with any number of waypoints, providing the maximum number of 2000

waypoints between all routes is not exceeded.

The Route (RTE) function serves two purposes:

The RTE1 screen provides all of the current, or active waypoint navigation data to

the Navigate and Plot screens and is referred to as the Active Route. Therefore,

whenever you begin a new trip or voyage, you should erase the previous voyage’s

waypoints in this screen, then insert the new waypoints or routes (from RTE2)

for the new voyage. If you want to store the waypoints from the previous active

route for future use, you can copy these waypoints in the order in which they were

entered to the Route Bank in the RTE2 screen. This is described in the RTE2 - The

Route Bank section of this manual. If you do not clear the RTE1 screen (refer to

Erasing an Existing Route section of this manual), the RTE1 screen will grow each

time you add new waypoints to the route. The route function can hold a maximum

of 2,000 waypoints between the routes stored in RTE1 and RTE2.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 199 200

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 30