Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 52)

50 | Keypad & Display Description

Scroll down the menu to 3 NMEA Out 1 (or which ever port number is required).

Press the

4 EDIT key.

If the port is already Active (

5 Yes), write down which NMEA sentences are set to

Yes, then set all of the NMEA sentences to No. You need to do this to record just

the waypoint data.

If the port is not Active (No), change it to Yes.

Scroll down to the

6 WPL record and change it On.

Highlight the

7 Details softkey and press ENT.

Set

8 Include Waypoint Names to either No or Yes. Refer to WPL -Waypoint Location

- NMEA Compliant and WPL - Waypoint With Symbols & Description - NMEA 0183

Non-Compliant sections in this manual to determine the correct format for your

purpose.

Set

9 Decimals in Position to 4.

Highlight the

10 Done softkey and press ENT.

Set the

11 WPL record to Off (you will need to turn the data off while setting up the

computer).

On the computer, double click on the

12 Accessories icon.

Double click on the

13 Terminal icon.

Click on the

14 Settings menu.

Double click on the

15 Communications menu item and make the following settings:

4800 baud

8 data bits

1 stop bit

Parity - none

Flow Control - none

Connector - Com1 (or Com2, depending where the external

interface is)

Parity Check - blank

Carrier Detect - blank

Click on the16 Transfers menu.

Double click on the

17 CDU Text File menu item and make the following settings.

[give the file a name.txt]

[select a location (folder) to store the file]

On the CDU, you should still be in edit mode on

18 CFG1 NMEA Out 1 with the cursor

ashing on Off at the WPL record. Press the Send All softkey.

When all the waypoint sentences are sent, click on the

19 Stop button on the PC.

Press the

20 EDIT key on the CDU to exit the edit mode.

Uploading Waypoints from Other Devices

The CDU will accept waypoints from any device which follows the WPL formats identified

earlier in the Waypoint section. The first two characters following the $ can be any NMEA

defined talker ID. You do not have to calculate and include the checksum; however, you

must end each data record with a carriage return and line feed. If you do include the

checksum at the end of the data record, the CDU will verify the checksum. If the checksum

is invalid, the waypoint will be rejected.

Waypoints received on the data port will be stored to the waypoint location specified in

the WPL record. If the waypoint location specified in the WPL record is already occupied,

the CDU will overwrite the existing waypoint (if it is unlocked). If the existing waypoint is

locked, the WPL record received on the input port will be ignored and dropped.

The CDU will only recognize waypoints from one input port at any given time. This port is

defined in CFG1 => WPT & RTE In.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 199 200

Kommentare zu diesen Handbüchern

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 52

Kommentare zu diesen Handbüchern