Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 33)

Keypad & Display Description | 31

the screen.

Waypoint 0, the first waypoint, is your Point of Departure, or the position you were at

when you created the route. Waypoint 0 is a unique waypoint, in that the CDU internally

changes the position of Waypoint 0 to your present position. However, the CDU saves

and displays the original coordinates entered when you created the route.

Waypoint 0 is displayed in Inverse Video, that is, white characters on a black background

(when in the normal Daylight display mode; see CFG1 Lighting). This indicates that

you have already passed this coordinate. The time stamp at the lower portion of the

description window indicates when the route was created. If you want to adjust your point

of departure position, you can edit Waypoint 0 in the WPT function.

To the right of the coordinate window of Waypoint 0 is a bent arrow. The bend in the

arrow is adjacent to the range and bearing between the waypoint you just passed and

the waypoint you are approaching. Keep in mind that these are the fixed calculated

values between these two coordinates and not the real time changing values that you

will see in the navigation screens between your present position and your next waypoint

during normal navigation.

Below Waypoint 0 is the waypoint you defined in the GOTO function. Notice that this

information is in standard video, black characters on a white background, and that an

ETA time is displayed in the same position as the waypoint passed time in Waypoint 0.

This indicates that the waypoint has not yet been passed. Remember that the ETA time

is filtered over time, so allow a few minutes for the filter to settle when you first get

underway or make course and speed changes.

Erasing an Existing Route

To erase the active route:

Select the

1 RTE key until the RTE1 screen is displayed.

Press the

2 EDIT key.

Highlight the

3 Remove softkey and press the ENT key.

Highlight the

4 Erase Route softkey and press the ENT key.

Highlight the 5 Yes softkey and press the ENT key to conrm.

The active route is now erased and ready for new input. If you want to work in other areas

of the CDU first, you will need to press the EDIT key to exit the edit mode.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 199 200

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 33