Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 35)

Keypad & Display Description | 33

When you have found the waypoint you want, highlight the 6 Insert this WPT softkey

and press ENT.

You can then choose to select another waypoint using the same method, highlight

Escape and press ENT to go back one level and use another method to enter

waypoints, or highlight Done and press ENT to go back to the main menu.

Don’t forget to press the

8 EDIT key to end your editing.

Choose in Bank

The following example assumes RTE1 is empty. Follow the directions in the Erasing an

Existing Route section to start with an empty route if you have waypoints in the RTE1

screen.

Select the

1 RTE key until the RTE1 screen is displayed.

Press the

2 EDIT key to enter the edit mode.

Highlight the

3 Insert softkey from the display and press ENT. Skip to the next step

if RTE1 is empty.

Highlight

4 Choose in Bank from the display and press ENT.

Select a waypoint by:5

Highlighting the Sort By softkey and press ENT to arrange the waypoints by a

number, name, type, distance, or age (refer to the Waypoint section for a full

description), then using the cursor key to scroll through the previously stored

waypoints in the Waypoint Bank.

Highlighting the Search for WPT softkey and press ENT. When using this

selection you actually spell out the name and or symbols of the waypoints

you are looking for and the software will display any waypoint containing that

combination of characters or symbols. Refer to the Waypoint section for a full

description.

When you have found the waypoint you want, higlight the 6 Insert this WPT softkey

then press ENT.

When you are nished, Highlight the

7 Done softkey then press ENT to get back to

the main menu.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 199 200

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 35