Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 120)

Simrad MX500 | 119

To set the DR to ‘Yes’ press the EDIT key then highlight

the ‘Change’ softkey and press the ENT key. Press the

EDIT key again to exit the edit mode.

Dual Control - Dual Station Control

This screen sets the functional control between two or

more MX500 CDU’s interfaced together. The default set-

ting is No. When this selection is changed to Yes, one

receiver is set to Master, the other receiver(s) is set to

Slave(s). If the MX500 is a Slave, it will have the Repeater

option. If Repeater is enabled, the MX500 only acts as a

display unit. A Repeater unit does not have the capability

to modify any setting unless a password (which is set by

the Master unit in CFG1/Security) is entered. These units

will share a common database and one antenna. Refer to

Appendix D for more detailed information about the dual

control and multiple unit control setup and operation.

CFG1/LAN must be setup before enabling this feature.

A dual control system consists of one Master and one

Slave. A multiple unit control system consists of one

Master, at least one Slave (maximum of two), and up to

three (if any) Repeaters. A multiple unit control system

must contain a minimum of three MX500 and a maximum

of ve MX500 units altogether.

In a Multiple Unit Control conguration, this option

must be enabled (by changing Dual Control to Yes

and press the EDIT key to exit edit mode) for all

Slave and Repeater units before enabling it in the

Master unit.

MX500 Dual Control Menu

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 261 262

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 120