Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 47)

46 | Simrad MX500

Waypoint 0 is displayed in Inverse Video, that is, white

characters on a black background (when in the normal

Daylight display mode; see CFG1 Lighting). This indicates

that you have already passed this coordinate. The time

stamp at the lower portion of the description window in-

dicates when the route was created. If you want to adjust

your point of departure position, you can edit Waypoint 0

in the WPT function.

To the right of the coordinate window of Waypoint 0 is

a bent arrow. The bend in the arrow is adjacent to the

range and bearing between the waypoint you just passed

and the waypoint you are approaching. Keep in mind

that these are the fixed calculated values between these

two coordinates and not the real time changing values

that you will see in the navigation screens between your

present position and your next waypoint during normal

navigation.

Below Waypoint 0 is the waypoint you defined in the

GOTO function. Notice that this information is in stan-

dard video, black characters on a white background, and

that an ETA time is displayed in the same position as the

waypoint passed time in Waypoint 0. This indicates that

the waypoint has not yet been passed. Remember that

the ETA time is filtered over time, so allow a few minutes

for the filter to settle when you first get underway or

make course and speed changes.

Erasing an Existing Route

To erase the active route:

Select the 1 RTE key until the RTE1 screen is dis-

played.

Press the 2 EDIT key.

Highlight the 3 Remove softkey and press the ENT

key.

Highlight the 4 Erase Route softkey and press the

ENT key.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 261 262

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 47