Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 141)

140 | Simrad MX500

Operation - General Setup and Control

Settings

This screen controls a few basic operating settings:

Remember Display: When set to Yes (default), the receiv-

er remembers the Page Number or screen you viewed

the last time you used a particular function. For example,

if you normally monitor the NAV3 display and you decid-

ed to look at the PLOT1 screen, the next time you press

the NAV function, the receiver will automatically revert

to the NAV3 screen immediately.

If you select No for Remember Display, the receiver will

always display the first page of a function when you

press the function key.

Edit Timeout: You can set the timeout limit between

None (default), or 1 to 10 minutes. If you enter the edit

mode on any screen and have a timeout period other

than None, the receiver will automatically exit the edit

mode if no keys are touched and the timeout period

expires.

Preceding Zeroes: Places zeroes (0s) before directions

less than 100° when Yes is selected. For example, 079°.

Otherwise directions are shown without the leading zeros

when No is selected (default). For example, 79°.

Beeper: If you attempt to perform a key function that

is not allowed, you normally hear an Error Tone. This is

performed when the Beeper is set to On (default). If you

don’t want to hear the error or any other keyboard beep,

set the Beeper to Off.

Retain External Alarm: Allows the CDU to hold the ex-

ternal alarm while the alarm condition still exist. When

Retain external alarm is set to On, the external alarm will

normalize only when the cause of alarm is corrected.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 261 262

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 141