Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 130)

Simrad MX500 | 129

Correction Factor - Allows you to make minor adjust-

ments to observed or measured errors in your speed

through water calculation. The input value will be multi-

plied by this value before it is used in the receiver. The

default value is 1.00.

Digital Pulse Input:

Pulses Pr. Nm - This is the calibrated pulses per speed

unit value that you must get from the speed log manu-

facturer.

Alarm If No Data - Causes an alarm to activate if data is

not received on the port you defined when Yes is select-

ed (the default condition). To disable the alarm, select No

with the Change softkey.

Correction Factor - Allows you to make minor adjust-

ments to observed or measured errors in your speed

through water calculation. The input value will be multi-

plied by this value before it is used in the receiver. The

default value is 1.00.

Both input types have a window in the lower portion of

the display which indicates the input value in real time.

If you input a calibrated pulse rate, you can check for the

appropriate speed right here.

You will be able to view the speed log information in the

NAV4 screen when it is implemented in future software.

Log Pulses - GPS SOG Log Pulse Output

This screen controls the output port (Pulse) of the

speed over ground log output from the MX500 CDU at a

user-defined pulse rate per nautical mile. This output is

normally used to feed GPS SOG to an ARPA radar. The

default state is not active, and set to 200 pulses per

nautical mile.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 261 262

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 130