Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 79)

78 | Simrad MX500

Uploading Waypoints from Other Devices

The CDU will accept waypoints from any device which

follows the WPL formats identified earlier in the Waypoint

section. The first two characters following the $ can be

any NMEA defined talker ID. You do not have to calculate

and include the checksum; however, you must end each

data record with a carriage return and line feed. If you

do include the checksum at the end of the data record,

the CDU will verify the checksum. If the checksum is

invalid, the waypoint will be rejected.

Waypoints received on the data port will be stored to

the waypoint location specified in the WPL record. If the

waypoint location specified in the WPL record is already

occupied, the CDU will overwrite the existing waypoint

(if it is unlocked). If the existing waypoint is locked, the

WPL record received on the input port will be ignored and

dropped.

The CDU will only recognize waypoints from one input

port at any given time. This port is defined in CFG1 WPT

& RTE In.

Uploading Waypoints from a Personal

Computer

You can use any terminal or communications program to

download or upload waypoints and routes to or from the

CDU and a PC.

Set the PC to:

4800 baud

8 bits

1 stop bit

no parity

no flow control

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 261 262

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 79