Memorex RX 1 Smart Installationshandbuch PDF herunterladen (Seite 222)

Simrad MX500 | 221

Appendix C - Engineering Mode

The Engineering Display, which is activated in CFG1

Operation, enables an expanded series of display screens

in some of the functions. In general, these screens are

used by the technician during troubleshooting or by

SIMRAD engineers during testing and software debug-

ging. This section describes what information is relevant

to you, or the information we need to help you trouble-

shoot your MX500.

Information which is not described here is unsupported,

which means SIMRAD will not expand or provide any

more information than what is provided in this manual.

If you should enable these screens, they will be turned

off automatically the next time power is cycled on the

MX500.

AUX7 - Unit Information & Self Test

When the Engineering Display is active, the AUX7 screen

adds one line of detail to display the engineering level

that is turned on.

In addition, you can press the EDIT function key and

run a complete self test by highlighting the Make Selftest

softkey then pressing ENT. The first display of the self

test is a keypad test. Press each function and softkey

once. When you have pressed each once the test will au-

tomatically advance to the Traffic Light test. Observe that

the three traffic lights go from dim to bright. Highlight

the OK softkey then press ENT if they illuminate cor-

rectly or Fail if they don’t.

The CDU will go on to conduct a Contrast test. Observe

that the display goes through its full range of contrast

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 261 262

Keine Kommentare

Memorex RX 1 Smart Installationshandbuch Seite 222